Rane SIXTY-EIGHT Owner's Manual download pdf (Page 32)

OWNER’S MANUAL

SIXTY-EIGHT

Fader Assembly Removal

1 Remove all ve fader knobs.

2 Remove all four screws holding the fader panel face

plate.

3 Lift up the fader panel face plate and set it aside

where it can’t get damaged.

4 Remove the two screws in the main panel at the top

of the fader assembly.

5 Remove the two screws at the front of the fader

assembly.

6 Slide the fader assembly out

just enough to see the three

white and blue wires and their

connectors.

7 Unplug the connectors of the

three white and blue wires.

8 Slide out the fader assembly

completely.

9 The channel faders are

mounted in pairs. Remove the

four screws for each pair of

faders (1 and 2) or (3 and 4).

0 The magnetic crossfader may be removed by

the two screws at each end of the crossfader.

Reverse this procedure to re-assemble.

• Plug in all three cables before installing screws.

• Conrm cables are not crossed, with

faders 1 & 2 on the left connector, faders

3 & 4 on the right connector, and the

blue crossfader wires in the center.

• Test all the faders before installing the fader panel

face plate and fader knobs.

1 2 ... 27 28 29 30 31 32 33 34 35 36

No comments

Rane SIXTY-EIGHT Owner's Manual Page 32