Rane SL 4 Operator's Manual download pdf (Page 22)

RANE SL4 FOR SERATO SCRATCH LIVE • OPERATOR’S MANUAL 2.5.0

22

DJ-FX Plugin

The DJ-FX Plugin gives you control of

two FX units, each with three chained

effects slots per unit. Each FX unit has

two control modes: Ultra Knob Mode and

Super Knob Mode, both of which can be

fully customized. The DJ-FX plugin opens

in Ultra Knob Mode by default.

To enable the DJ-FX Plugin, go to the

Plugins tab in the Setup screen, choose

DJ-FX and check Enable DJ-FX Plugin.

Once enabled, the DJ-FX panel button

appears in the panels area on the main

screen.

NOTE: The DJ-FX plugin is not visible

if your Rane hardware is not connected.

Ultra Knob Mode

Click the Ultra Knob Mode

button to select Ultra Knob

Mode. This allows you to control up to

three effects slots in one FX unit using the

one Ultra Knob.

Click on the drop down menu to load an

Ultra Knob effect. (This is “empty” before

settings are saved in Macro Edit Mode.)

Click the ON button to enable the effect,

and use the Ultra Knob to control the wet

and dry amount of all effects.

Click the Show Parameters button

to show the effects and parameters

that are controlled by the loaded

Ultra Knob preset.

Super Knob Mode

Super Knob Mode allows you

individual control of each effect

in the FX unit. Each effect slot has a Super

Knob which controls the wet and dry

amount for the effect.

Click the Effects drop down box to

select an effect for the effect slot. You can

leave a slot empty by selecting “empty.”

Click the ON button by the Super

Knobs to toggle turning the effect(s) on

and off.

The effects chain works in series going

from effects slots 1 to 3, meaning that the

effected audio from slot 1 passes through

slot 2, which is then passed through slot

3.

Effects BPM Multiplier

The Effects BPM

Multiplier is used to

adjust the effect time. The effect time is

set using the track’s BPM value, but by

applying the Effects BPM Multiplier you

can increase or decrease the effect time.

Deck Assign

You can select which Deck the FX unit

applies to by clicking the Deck buttons.

Each Deck can only pass through one FX

unit at a time.

Show Parameters

Press the Show Parameters button

to expose the individual parameters

for each effect. You can then control

the individual parameters by adjusting

their respective knobs.

In Ultra Knob Mode, use this to select

which effects are loaded and controlled by

the Ultra Knob.

In Ultra and Super Knob Mode, you

can link or unlink a parameter to the

Super Knob by pressing the Link Button,

allowing one master control of some

parameters and individual control of

others.

Macro Edit Mode

Macro Edit Mode is an advanced

option that allows you to create

macro mappings for each effect and to

save any effects edits made in Ultra or

Super Knob Mode. Open Macro Edit

Mode by clicking the Macro Edit Button

while Show Parameters is open. Once

opened, more controls appear which

allow you to create and change parameter

mappings.

To map a parameter to the Ultra or Super

Knob:

1. Unlink the parameter that you want

to map to the knob. The Macro Min

and Max buttons for this parameter are

now displayed.

2. Move the Ultra or Super Knob

to the position that you want the

parameter to start mapping from.

3. Move the Parameter Knob to the

position that you want the to be the

lowest value of the parameter.

4. Press the Macro Min button to set

the minimum position.

Macro Edit Mode

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 43 44

Comments to this Manuals

No comments