BY DJ RAZY
8.3 Software & Hardware Settings
Switch to Ableton live and chose switch your interface from „Serato“ to CoreAudio (Mac) or ASIO (Win).
After that chose your stereo input and your stereo output.
Now you are able to route your audio signals through Ableton Live! The main work is done so far.
Tip: Check out the latency between the „original signal“ and the signal that you route through Ableton Live.
The signal should be at least the same when you pull the dry & wet fader to the right. If not, the latency is too
high.
Reduce your sampling-rate from 48 kHz into 44,1kHz. You can also chance the global latency.
Page - 23 -
Comments to this Manuals