Rane TTM 57SL Operator's Manual download pdf (Page 30)

Manual-30

The hardware control panel

When you connect the TTM 57SL to Scratch LIVE, the hard-

ware control panel appears. You can show or hide this panel by

clicking on the hardware button.

You can control many of the features of Scratch LIVE directly

from your TTM 57SL mixer. e hardware panel shows you

what functions in the software are connected to the physical

controls on the mixer, and allows you to customize the control

assignments. It also provides an interface for the eﬀects running

in the mixer.

Controlling Scratch LIVE from the TTM 57SL

Each of the controls on the mixer controls a software function in

Scratch LIVE.

Each parameter knob (labeled P1 and P2 on the mixer) has

two states. e LED next to P1 and P2 on the mixer indicates

the state: the control above applies when the LED is oﬀ, the

control below applies when the LED is on. Some controls, such

as “tap tempo”, and “load track” are momentary.

e joysticks J1 and J2 also have two states. When the LED

next to J1 or J2 is on, the joystick controls Scratch LIVE soft-

ware. When the LED is not lit, the joystick acts as a transform

switch. To switch between using the joystick as a control for

Scratch LIVE and a transform switch, press the joystick straight

down and hold it down. Note: the joystick is also a button, press

it straight down, as if you were trying to push it into the mixer

— you will hear it click.

When you are in transform mode, the LED next to the

joystick is not lit, and its controls on the Scratch LIVE hardware

panel are grayed out.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 41 42

No comments

Rane TTM 57SL Operator's Manual Page 30