Rane TTM 57SL Operator's Manual Page 6

  • Download
  • Add to my manuals
  • Print
  • Page
    / 42
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 5
Manual-6
+12-12
+12-12
10
OL
0
2
4
8
6
100
64
2 8
MIC LOW
MIC HIGH
MIC LEVEL
AUX IN
MIC ON
100
100
64
2 8
64
2 8
100
64
2 8
100
64
2 8
OUTPUT
LEVELS
MAIN
BOOTH
AUX OUT
PHONES
PGM 1
CUE
PGM 2
MASTER
CUE
AUX IN
is level adjusts the level of the Auxiliary Input signal. is is a
full-range control providing Off to +6 dB gain adjustment.
MIC LEVEL and EQ
e MIC ON switch engages the Mic. e green indicator is lit
when the MIC is engaged.
MIC LEVEL adjusts the Mic gain over a range of Off to +50
dB. Set the gain where you want it and use the MIC ON switch
to turn the MIC on and off.
e OL indicator lights when the signal reaches clipping. If
this lights red, turn the MIC LEVEL down.
MIC HIGH and MIC LOW tone controls allow you to
adjust the bass and treble of the MIC Input signal.
OUTPUT LEVELS
Output Level controls are provided for MAIN, BOOTH and
AUX Outputs. All three outputs have the same Main Mix
source. As shown previously in Analog Outputs, the Main out-
put is a balanced output on XLR connectors, the Booth output
is a balanced signal on TRS connectors and the AUX output is
an unbalanced signal on RCA connectors. is combination of
jacks allows you to hook into other equipment regardless of the
connector type.
Headphone Cueing
e Cueing system allows users to Pan the Cue from PGM 1 to
PGM 2 or select the Master Mix. Cueing is also provided for the
internal digital effects, covered on page Manual-9.
Both 3.5 mm and ¼" jacks are provided. ese can be used
simultaneously, but using only one at a time yields more power
to the headphones.
PHONES
e headphone output can deliver very high volume to some
headphones. To avoid pain, never put headphones on your head be-
fore plugging them in. Always start with the Phones Level turned
down, and then turn it up to the desired level.
CUE
is slider allows you to pan between PGM 1 and PGM 2 in the
headphones when the Master Cue light is o. When Master Cue
is on, this control has no effect. e cue signals are post-EQ and
pre-fader.
MASTER CUE
Press this switch (green light on) to hear the Main Mix in the
headphones. When this light is o, the Cue slider takes over.
HEADPHONES
(XLR)
(TRS)
(RCA)
Page view 5
1 2 3 4 5 6 7 8 9 10 11 ... 41 42

Comments to this Manuals

No comments