Rane TTM 57SL Operator's Manual download pdf (Page 2)

Important Safety Instructions

1. Read these instructions.

2. Keep these instructions.

3. Heed all warnings.

4. Follow all instructions.

5. Do not use this apparatus near water.

6. Clean only with a dry cloth.

7. Do not block any ventilation openings.

Install in accordance with manufacturer’s

instructions.

8. Do not install near any heat sources

such as radiators, registers, stoves, or

other apparatus (including ampliers)

that produce heat.

9. Do not defeat the safety purpose of

the polarized or grounding type plug.

A polarized plug has two blades with

one wider than the other. A grounding-

type plug has two blades and a third

grounding prong. The wide blade or

third prong is provided for your safety.

If the provided plug does not t into

your outlet, consult an electrician for

replacement of the obsolete outlet.

10. Protect the power cord and plug from

being walked on or pinched particularly

at plugs, convenience receptacles,

and the point where it exits from the

apparatus.

11. Only use attachments & accessories

specied by Rane.

12. Use only with the cart, stand,

tripod, bracket, or table specied by

the manufacturer, or sold with the

apparatus. When a cart is used, use

caution when moving the cart/apparatus

combination to avoid injury from tip-

over.

13. Unplug this apparatus during lightning

storms or when unused for long periods

of time.

14. Refer all servicing to qualied service

personnel. Servicing is required when

the apparatus has been damaged in any

way, such as power supply cord or plug

is damaged, liquid has been spilled or

objects have fallen into the apparatus,

the apparatus has been exposed to rain

or moisture, does not operate normally,

or has been dropped.

15. The plug on the power cord is the

AC mains disconnect device and must

remain readily operable. To completely

disconnect this apparatus from the AC

mains, disconnect the power supply

cord plug from the AC receptacle.

16. This apparatus shall be connected to

a mains socket outlet with a protective

earthing connection.

17. When permanently connected, an

all-pole mains switch with a contact

separation of at least 3 mm in each pole

shall be incorporated in the electrical

installation of the building.

18. If rack-mounting, provide adequate

ventilation. Equipment may be located

above or below this apparatus, but

some equipment (like large power

ampliers) may cause an unacceptable

amount of hum or may generate

too much heat and degrade the

performance of this apparatus.

WARNING: To reduce the risk of re

or electric shock, do not expose this

apparatus to rain or moisture. Apparatus

shall not be exposed to dripping or

splashing and no objects lled with

liquids, such as vases, shall be placed on

the apparatus.

Warning

To reduce the risk of electrical shock, do

not open the unit. No user serviceable

parts inside. Refer servicing to qualied

service personnel. The symbols shown

below are internationally accepted

symbols that warn of potential hazards

with electrical products.

This symbol indicates that

there are important operating

and maintenance instructions

in the literature accompanying

this unit.

This symbol indicates

that a dangerous voltage

constituting a risk of electric

shock is present within this

unit.

These stickers are located on the bottom

of the mixer.

RISK OF ELECTRIC SHOCK

DO NOT OPEN

CAUTION

FCC Statement

This equipment has been tested and

found to comply with the limits for a Class

B digital device, pursuant to part 15 of

the FCC Rules. These limits are designed

to provide reasonable protection against

harmful interference in a residential

installation. This equipment generates,

uses and can radiate radio frequency

energy and, if not installed and used

in accordance with the instructions,

may cause harmful interference to

radio communications. However, there

is no guarantee that interference will

not occur in a particular installation.

If this equipment does cause harmful

interference to radio or television

reception, which can be determined

by turning the equipment off and on,

the user is encouraged to try to correct

the interference by one or more of the

following measures:

• Reorient or relocate the receiving

antenna.

• Increase the separation between the

equipment and receiver.

• Connect the equipment into an outlet on

a circuit different from that to which the

receiver is connected.

• Consult the dealer or an experienced

radio/TV technician for help.

CAUTION: Changes or modications not

expressly approved by Rane Corporation

could void the user’s authority to operate

the equipment.

This Class B digital apparatus complies

with Canadian ICES-003.

Cet appareil numérique de la classe B

est conforme à la norme NMB-003 du

Canada.

RANE TTM 57SL MIXER FOR SERATO SCRATCH LIVE • OPERATOR’S MANUAL 2.4.4

1 2 3 4 5 6 7 ... 59 60

Comments to this Manuals

No comments

Rane TTM 57SL Operator's Manual Page 2

Comments to this Manuals

Related products and manuals for Audio mixers Rane TTM 57SL